Vigo VG06031 User Manual

Page 13

MODEL VG06031

IMPORTANT

ROLLER ADJUSTMENTS TO ACCOMMODATE OUT OF SQUARE OPENINGS

Loosen the hex screw to allow for movement. Then place the allen key in the small hex hole as

shown and roll it to the right or left to make the adjustment. [See Fig.1]

Fig. 1A displays the 3 different positions.

If your walls are plumb and level, follow the configuration in Fig. 2.

In the case that your wall is off on the top, the rollers should be adjusted as shown in Fig. 3.

In the case that your wall is off on the bottom, the rollers should be adjusted as shown in Fig. 4.

FIG. 1

HEX SCREW

ROLLER (3)

SMALL HEX

HOLE

SMALL HEX
HOLE

3/8" VARIANCE

Lowest position

Normal position

Highest position

FIG. 1A

IMPORTANT

NOTE: These adjustments are approximate. You may need to adjust the direction of the small
hex hole to meet your needs.

NOTE: There is a 3/8" adjustment in the roller to use in the case that your walls are not plumb

and level. Using an allen key, you will be able to adjust the roller to accommodate for the

variance.