UVP Crosslinkers - Manual (Page 10)

UV CROSSLINKERS UVP
10
14. Set the radiometer scale to 20mW/cm
2
.
15. Connect the radiometer to PEN 2 of the chart recorder.
16. Select 1V scale for PEN 2 and a speed of 60mm/min.
17. Lower both pens, turn the CHART DRIVE switch on, change the pens' switches to MEASURE
position and adjust for zero level.
18. Select an energy level of 600 Joules on the Crosslinker and press the START button.
19. When the cycle is completed, repeat for 1,200 and 2,000 Joules levels.
20. Obtain the actual amount of energy in Joule/m
2
by calculating the area encompassed by the
recorded data curve and zero baseline times 100. Compare it with the energy selected. They
should be within a range of +/- 10%. If this is not the case, adjustments of potentiometers R21
and R29 should be made during a repeat calibration. Repeat all the above procedures until the
actual levels are within range.
21. When the three levels of energy are acceptable, disconnect the sensor and the chart recorder
from the Crosslinker. At this point, the unit is ready to be tested.
REPLACEMENT PARTS
PART NO.
A.
OPERATIONS WITHOUT REMOVING THE TOP COVER 5 x 34-0007-01
Changing tubes
B.
OPERATIONS WITH TOP COVER REMOVED
Replacement of tube holders 10 x 36-0003-01
Replacement of starters 5 x 53-0001-02
or 53-0132-01
Replacement of starter holders 5 x 36-0005-01
Replacement of fuse holders 2 x 56-0023-02
Replacement of main connector 55-0105-01
Replacement of main switch 53-0134-01
Replacement of UV sensor 39-0006-01
Replacement of PCB 57-0014-01
Replacement of membrane panel 53-0133-01
C.
OPERATIONS WITH THE INTERNAL CHASSIS ASSEMBLY REMOVED
Replacement of reflector 16-0095-01
D.
OPERATIONS WITH REFLECTOR REMOVED
Replacement of micro-switch 53-0072-01
Replacement of ballasts 5 x 42-0005-03 100V
5 x 42-0005-04 230V
5 x 42-0005-01 115V
Replacement of magnetic door holders 2 x 67-0019-01
E.
GENERAL ITEMS
Changing fuses 2 x 56-0022-02
Changing plastic feet 4 x 72-0004-01