Unisteer 8011090-01 Camaro Power Rack & Pinion 1970-81 - Manual (Page 6)

655840 Page 6
20. Once you have the pump mounted and the belt installed and tight. You may now connect your
pressure and return line. The pressure line goes from the bottom port on the rack to the top port on
the pump. The return line goes from the upper port on the rack to the slip on portion of the reservoir.
Tighten all fittings to 30 ft lbs. Tighten hose clamp on reservoir.
21. Top off power steering fluid and start vehicle. Turn wheel back and forth to purge out any air in the
system. Turn off vehicle and let sit for a while top off fluid and recheck.
22. Check your toe adjustment by trying to eye up how straight your tires are in the straight ahead
position. Set your toe by turning your tie rods in or out as needed to position.
23. You will need your car aligned by a professional shop. The above adjustment is to get your car to the
shop to get it aligned.
If you have any questions or problems regarding this product please contact:
UNISTEER®
Performance Products
1555 Enterprise Parkway
Twinsburg OH 44087
800-338-9080
WWW.UNISTEER.COM
Last Revised 6/19/2014
Copyright © 2009 by Maval Manufacturing Corporation All rights reserved.
No part of these materials can be reproduced or utilized in any form or by any means, electronic
or mechanical, including photocopying, recording or by any information storage and retrieval
system, with permission in writing from Maval Manufacturing Corporation.