Unisteer 8011090-01 Camaro Power Rack & Pinion 1970-81 - Manual (Page 3)

655840 Page 3
2. Remove power steering pump and brackets from engine. Disconnect pressure and return line from
pump.
3. Raise vehicle and remove outer tie rod ends and cotter pins from steering arms. Remove idler arm
assembly from passenger side of vehicle. Remove drag link from pitman arm.
4. Remove stock steering linkage from the vehicle. Remove the 3 bolts on the outside of the driver side
frame that hold the gearbox to the vehicle, then remove the entire gearbox. Note: this may require
wiggling the box off of the steering shaft.
5. From under the hood, remove the pinch bolt at the top of the steering column. Slide the stock shaft off
of the column.
6. You are now ready to install the new system.