Unisteer 8010540-02 Camaro 1967-69/Nova 1968-74 Power Rack & Pinion User Manual
Page 6
pg. 6
655410
3) Mock the new 2-joint SBC steering shaft shown below
SOLD SEPERATELY
(# 8050490)
between the rack and pinion and the steering column, to determine the exact size. If you
have a big block you will need a 3-joint kit.
Small Block Kit
Big Block Kit
4) Trim the steering shaft to size. Be sure to Mis-Phase the steering U-Joints (see
illustration on next page). Drill through the u-joint yoke and shaft with the 1/4 inch drill
provided. Pin the u-joint to the shaft, using the large pin, and finish by driving the small
pin into the large pin. Install the u-joints on the column and the steering gear. Be sure to
dimple the column shaft. Tighten fasteners.
Note: When installing this kit in a car with a big block, you are limited to specific
shaped headers. We used Patriot H8012. It will also be necessary to use 3 steering u-
joint when installing this kit with a big block.