Unisteer 8010540-02 Camaro 1967-69/Nova 1968-74 Power Rack & Pinion - Manual (Page 5)

pg. 5 655410
5) Install the new steering arms using the factory bolts that you removed earlier (see below).
Torque the bolts to 85 ft/lbs.
6) Adjust the outer tie rod ends so that each side is on equally (see next page). Insert the outer tie
rod stud into the steering arm hole and nut the stud. Torque to 35 ft/lbs.
Steering Shaft Installation
*For factory column, aftermarket column requires different shaft kits, call for assistance.
1) Remove the steering coupler from the steering column. This is held in place with two
bolts. If you’re using an aftermarket column this does not apply.
2) Install new column adaptor kit shown below SOLD SEPERATELY (# 8020820) by bolting
it in place.