Unisteer 8000770-02 Camaro 1967-69/Nova 1968-74 - Manual (Page 3)

pg. 3 655420
Installation
1. Remove the driver side rear lower control arm bolt. To do this use one of the new bolts that is
provided, and drive the old bolt out with the new bolt. Using the other new bolt, drive the bolt
you just installed out so that the threaded end of the new bolt is facing the back of the car.
You may need to draw the bolt through by tightening the nut, if so remove the nut after the
bolt has been completely drawn through. Install one of the steel spacer (stand off) provided.
2. Prepare to remove the passenger side control arm bolt. Shift the jack to the passenger side.
3. After removing the nut, drive the old bolt out using the old driver’s side bolt. Take the
remaining new bolt and drive out the old bolt you just installed back out so that the treaded
end is facing the back of the car. Drive the bolt through, just enough for the stand off and the
rack bracket to hang on.
4. Hang the new rack and pinion on the two 2 control arm bolts (see above). Install the new nuts
and torque to 85 ft/lbs.
5. 5) Adjust the outer tie rod ends so that each side is on equally (see next page). Insert the
outer tie rod stud into the steering arm hole and nut the stud. Torque to 35 ft/lbs.