Unisteer 8010280-01 Chevy Impala 1965-1966 - Manual (Page 9)

Page 9 656980
11. Once your pump and rack are installed you are now ready to install the hoses. Banjo fittings and
sealer come with the rack and will need to be installed and tightened down pointing in the correct
position that works best for your car all at one time. Once seal is tightened down and broken it may
not seal up again.
12. The pressure line is installed from the lower larger port on the rack to the threaded top banjo fitting on
the pump. The return line then goes from the upper smaller port on the rack to the slip on fitting on
the side of the reservoir. Snug down all fittings.
Pressure Port
Return Port