Unisteer 8011570 Ford Fairlane Rack 1963-1965 - Manual (Page 9)

Page 9 656250
17. Next install the pressure and return line. Note the pressure line has the 1 female end on each end.
That line runs to the lower port on the rack and the top port of the power steering pump. The return
hose goes to the upper port of the rack and the slip on end goes over the reservoir plastic nipple with
a hose clamp. Tighten all lines to 15 ft lbs. Make sure your line routing is good. Do not route lines so
they kink or come in contact with hot or sharp surfaces.
18. Next install you steering wheel, nut, and horn pad.
19. Top off the reservoir with power steering fluid. Start the motor and let idle to purge air from system.
Do not turn wheel. Top off fluid again right away. Restart vehicle and turn wheel right to left without
going to stops to purge air. Verify full reservoir and verify no leaks.
20. You will now need to take the vehicle to a qualified shop for an alignment.
If you have any questions or problems regarding this product please contact:
UNISTEER
Performance Products
1555 Enterprise Parkway
Twinsburg OH 44087
800-338-9080
WWW.UNISTEER.COM
Created on 01/31/2011
Last Revised on 6/24/2014
Copyright © 2011 by Maval Manufacturing Corporation. All rights reserved.
No part of these materials can be reproduced or utilized in any form or by any means, electronic
or mechanical, including photocopying, recording or by any information storage and retrieval
system, without permission in writing from Maval Manufacturing Corporation.