Unisteer 8011570 Ford Fairlane Rack 1963-1965 - Manual (Page 7)

Page 7 656250
12. Install the flat washers and locknuts to the outside of the frame. Once the bracket is in the car hold it
parallel to the ground and tighten the bolts to 50 ft lbs.
13. You can now eye up your tires toward the straight position and connect your outer tie rod ends and
install supplied cotter pins. Install grease fittings.
14. Install the supplied pinion joint onto the pinion and start the 6 mm pinch bolt. Install the supplied
column shaft into the column and slide it down till the end of the shaft just pokes through the column
bearing. Install the intermediate shaft into the pinion joint and start the pinch bolt. Next have someone
hold the column joint in place over the top of the spline on the intermediate shaft making sure the u-
joints are out of phase 90 degrees. Next aim the top part of the joint toward the column shaft and
have someone slide the shaft down through the joint and engage it with the pinch bolt.