beautypg.com

Unisteer 8011660 Ford Full-Size Rack & Pinion Kit 1949-1951 User Manual

Page 9

background image

Page 9

656480

4.

Route supplied horn wire through the firewall connecting the horn contact switch and the connector
on the stock wiring harness. (Located on inside of driver side front fender).

5.

Bolt new Power Rack and Pinion kit up from under vehicle. Using 2 holes on each side of frame,
(driver side = two of the three holes that held steering gear box to chassis, Passenger side = Two
holes that held steering linkage bracket to chassis). Do not tighten bolts yet.

6.

Install steering column tube support bracket onto driver side of kit on the inboard of the rack
bracket. Do not tighten yet.