Unisteer 8011660 Ford Full-Size Rack & Pinion Kit 1949-1951 - Manual (Page 6)

Page 6 656480
11. Remove Stock exhaust manifolds.
Modifications to Stock components:
1. On column tube, measure 5 5/8” up from the bottom flange and make a mark. This mark is where
you will cut the tube.
Cut the column tube on the 5 5/8” mark.
2. Measure down from backside of the steering wheel end of column, 22”. Now make a mark 1” from
the shift tube. Where these two marks intersect is where you will make the 9/16” diameter hole
that the horn contact switch will fit in.
5 5/8” from
bottom flange