Therma-Tru Doors Finishing Instructions - Manual (Page 14)

2.14 2014 SITE 2
Doorlite Frame Finishing
THERMA-TRU DOORS Technical Services Department
1750 Indian Wood Circle 1-800-THERMATRU (843-7628)
•
• Maumee, Ohio• 43537 • www.thermatru.com
TO REMOVE GLAZING COMPOUND
TO FINISH THE FRAME AROUND GLASS
PAINT
STAIN
LAMINATED GLASS
WARRANTY
Wet with window cleaner or water first. Use razor blade to score glazing along edge of
frame. Holding razor blade at a 45 deg. angle, scrape glazing from glass. Wipe remaining
residue off with window cleaner or mineral spirits.
It is recommended that a paintable caulk be applied to the exterior and interior frame
corner joints (including screw channel covers) to achieve maximum weather and
aesthetic performance. Clean entire frame with mild detergent and water or TSP
solution. Rinse well and allow to dry.
Prime first with an alkyd-or acrylic-based primer and allow to dry. Then paint with a high
quality, exterior grade acrylic-latex house paint.
Obtain Therma-Tru available “Buff Primer Kit” and apply to entire frame and all screw
channel cover pieces. Allow to fully dry. Apply Therma-Tru available “Stain Kit” to entire
assembly according to directions.
Meets the ASTM C1172 standard for laminated glass. During the stringent laminated
manufacturing process, inherent marks may appear. Slight bubbles, lines or surface
imperfections are not considered as glass defects.
This product is covered by a limited warranty. The warranty does not cover defects that
are a result of finishing or installation not in accordance with our instructions. For further
information contact:
LABEL TO BE REMOVED BY
HOMEOWNER OR END USER ONLY
ATTENTION HOMEOWNER
9/5/07
DLLBLHAT
Impact Frame