beautypg.com

Doorlite frame finishing, Assembled in mexico – Therma-Tru Doors Finishing Instructions User Manual

Page 13

background image

Finishing Instructions

SITE 2

2014

2.13

Doorlite Frame Finishing

9/5/07

DLLBLFG

TO REMOVE GLAZING COMPOUND:

FINISH DOOR WITHIN 6 MONTHS OF EXPOSURE.

PAINT:

STAIN AND TOPCOAT: For Classic-Craft and Fiber-Classic products use a

Therma-Tru Finishing System Kit

.

Therma-Tru Finishing System Kit

www.thermatru.com

1-877-99-STAIN (997-8246).

Wet with window cleaner or water first. Use razor

blade to score glazing along edge of frame. Holding razor blade at a 45° angle, scrape

glazing from glass. Wipe remaining residue off with window cleaner or mineral spirits.

Clean first with mild detergent and water or TSP solution. Rinse well and allow

to dry completely. Prime first with an alkyd- or acrylic-based primer and allow to dry.

Then paint with a high quality, exterior grade, acrylic-latex house paint.

Note: Smooth-Star Doors do not need a primer before painting.

To order a

,

contact your local Therma-Tru dealer, visit us on the Internet at

or

call toll free at

See the Finishing System Instruction

brochure or the Corner Door Tag for more detailed application information.

®

®

only

THERMA-TRU DOORS Technical Services Department

1750 Indian Wood Circle • Maumee, Ohio 43537 1-800-THERMATRU (843-7628)

• www.thermatru.com

ASSEMBLED IN MEXICO

FLUSH-GLAZED DOORS

AND SIDELITES

CAUTION:

DECORATIVE GLASS:

WARRANTY INFORMATION:

Complete curing of the finish over a fiberglass product generally

requires a longer period of time than other surfaces.

Our Therma -Tru artisans have hand-crafted the

decorative glass in this door system, and as with any hand-crafted product, no two

are alike. Slight irregularities and imperfections should not be considered defects.

This product is covered by a limited warranty. The

warranty does not cover defects that are the result of finishing or installation not in

accordance with our instructions. For further information contact: