Therma-Tru Doors Finishing Instructions - Manual (Page 11)

Finishing Instructions
SITE 2 2014 2.11
Doorlite Frame Finishing
9/5/07
DLLBLBTS
TO REMOVE GLAZING COMPOUND: Wet with window cleaner or water first. Use razor
blade to score glazing along edge of frame. Holding razor blade at a 45∞ angle, scrape
glazing from glass. Wipe remaining residue off with window cleaner or mineral spirits.
THERMA-TRU DOORS Technical Services Department
1750 Indian Wood Circle • Maumee, Ohio 43537 1-800-THERMATRU (843-7628)
•
• • www.thermatru.com
ASSEMBLED IN MEXICO
No yellowing
No warping
Can be painted a dark color
Can be used behind a storm door
•
•
•
•
Frames are colorfast and will provide acceptable service if left unpainted, OR,
Clean first with mild detergent and water or
TSP solution. Rinse well and allow to dry.
Prime first with an alkyd- or acrylic-based primer and allow to dry. Then paint with
a high quality, exterior grade acrylic-latex house paint.
TO FINISH THE FRAME AROUND GLASS:
PAINT:
CAUTION:
DECORATIVE GLASS:
WARRANTY INFORMATION:
Complete curing of the finish over a polymer part generally requires a longer
period of time than on other surfaces.
Our Therma-Tru artisans have hand-crafted the decorative glass in
this door system, and as with any hand-crafted product, no two are alike. Slight irregularities
and imperfections should not be considered defects.
This product is covered by a limited warranty. The warranty
does not cover defects that are the result of finishing or installation not in accordance with our
instructions. For further information contact:
Durable BTS Doorlite Frame