TCI HGA Quick Start - Manual (Page 3)

3
Warning
Be sure to read, understand, and follow all safety instructions.
Warning
Only qualified electricians should carry out all electrical installation and maintenance work on the
HarmonicGuard Active Filter (HGA).
Warning
All wiring must be in accordance with the National Electrical Code (NEC) and/or any other codes that
apply to the installation site.
Warning
Disconnect all power before working on the equipment.
Do not attempt any work on a powered Active Harmonic Filter.
Warning
The HGA, drive, motor, and other connected equipment must be properly grounded.
Warning
The HGA may receive power from two or more sources.
Three-phase power is connected to the main input terminals of the HGA.
All of these sources of power must be disconnected before working on the HGA.
Warning After switching off the power, always allow 5 minutes for the capacitors in the HGA and in the drive
to discharge before working on the HGA, the drive, the motor, or the connecting wiring. It is good
practice to check with a voltmeter to make sure that all sources of power have been disconnected and
that all capacitors have discharged before beginning work.
NOTE: Full User Manual
• For the full user manual and other supporting
documentation please go to:
http://www.transcoil.com
http://www.transcoil.com
!
!
!