Regency Energy U32E Medium Gas Insert - Manual (Page 37)

U32E-5 FPI Direct Vent Gas Insert
37
MAINTENANCE
VALVE REPLACEMENT
1) Shut off the gas supply.
2) Remove the louvers (and bay door if installed).
3) Open the fl ush door and remove the door.
4) Remove the logs and brick panels.
5) Remove the grate by loosening the two screws and sliding the grate
out.
Grate screws
6) Remove the burner assembly by removing the 2 screws and lifting
it out.
7) Remove the 2 screws holding the Air Intake Hood to the rear fi rebox
wall and lift out.
8) Disconnect the inlet gas line.
9) Disconnect the EV1, EV2, and ground wires from the valve - as shown
below.
11) Push the valve assembly to the left and lift the entrire assembly out.
12) Replace with new valve tray assembly and reverse steps 10 - 1.
10) Remove the 11 screws securing the valve tray in place - then lift the
entire assembly out.
EV1
EV2
Ground