Regency Hampton H300 Large Wood Stove - Manual (Page 18)

18
Hampton H300 Cast Freestanding Woodstove
INSTALLATION
DOOR REMOVAL BRICK INSTALLATION
Firebrick is included to extend the life of your
stove and to radiate heat more evenly. Check
to see that all fi rebricks are in their correct
positions and have not become misaligned
during shipping.
Spring Lever
1) Push spring lever down while holding onto
the door.
2) Pull door down and lift out to remove. Bottom
of door lifts right out.
Bottom part of door
fi ts into slot.
Glass Retainer
Remove 12 screws.
GLASS INSTALLATION
1) Remove door from unit.
2) To replace the glass remove the 12 screws
highlighted in the diagram below.
3) Lift off the glass retainer and carefully remove
glass.
4) Place new glass in the door, make sure
that the glass gasketing will properly seal
your unit.
5) Position the glass retainer back on. En-
sure that it rests on the gasket and not the
glass.
6) Secure glass retainer using the 12 screws.
Do not wrench down on the glass as this
may cause the glass to break.
7) Place door back on unit.