Summit VC60D - Manual (Page 18)

CARE AND MAINTENANCE
Warning: Failure to unplug the appliance
during service and cleaning could result
in electrical shock or other personal
injury.
REMOVING SHELVES
• To remove any of the shelves from the
rail compartment, move the shelf to
the position where the notch of the
wooden shelf is exactly under the
plastic post and then lift it up and out.
• In order to replace the shelf, repeat
the steps described above in reverse.
And make sure to engage the shelves
with the small pegs of the extended
rails when the model is equipped with
a roller system.
CLEANING YOUR WINE CELLAR
• Turn off the power, unplug the
appliance and remove all items,
including shelves/racks.
• Wash the inside surfaces with a warm
water and baking soda solution. The
solution should be about 2
tablespoons of baking soda to a pint
of water.
• Wash the shelves with a mild
detergent solution.
• Wring excess water out of the
sponge or cloth when cleaning any
area of the controls.
• Wash the outside cabinet with
warm water and mild liquid
detergent. Rinse well and wipe
dry with a clean soft cloth.
• Do not clean the stainless
steel with steel wool pads.
Instead, use an all-in-one
stainless steel cleaner to
clean the stainless steel.
Always wipe in the
direction of the grain.
POWER FAILURE
• In the event of a power
interruption, all previous
temperature settings are
automatically memorized. If
power is interrupted (power
surge, breaker switch, etc.)
and then powered up again,
the unit will operate with the
last temperature set-point.
• Most power failures are
corrected within a few hours
and should not affect the
temperature of your
appliance if you minimize
the number of times the
door is opened. If the power
is going to be off for a longer
period of time, you need to
take the proper steps to
protect the contents.
Note: Irrespective of the cause,
if you notice either abnormal
temperature or humidity
levels inside your wine cellar,
be reassured that only long
17