Bose Acoustimass 6 - Manual (Page 12)

12 December 20, 2001 AM189815_04_V.pdf
LEFT CENTER RIGHT LEFT RIGHT
SURROUND SURROUND
FROM RECEIVER OR AMPLIFIER
L C R LS RS
INPUTS
R C L
RS LS
TO CUBE SPEAKERS
L C R LS RS
OUTPUTS
SURROUND SPEAKERS
L REAR R CENTER
FRONT SPEAKERS
R L
Setting Up
Check the connections
Check all connections from the receiver to the Acoustimass ® module and the module to the
cube speakers, making sure the two speakers with black terminals are connected as front
speakers (Figure 11). Check to be sure all speakers are connected to the proper terminals
according to their position in your room (Figure 12).
At the receiver, make sure the wires are connected in phase (+ to + and – to –). Incorrect
wiring can result in a total loss of Acoustimass module output.
Be sure to correct any wiring problems before you plug your receiver in and turn it on.
Figure 12
Completed connections
L/R
Figure 11
Black connector and terminal
marked L/R on both the front left
and front right speakers
CAUTION:
Do not allow exposed wires to
brush against each other; this
could damage your receiver.