SPYPOINT SMART-8 User Manual - Manual (Page 11)

11
I.T.T. mode (Advanced configuration)
ADVANCED CONFIGURATION USING THE SMARTSET SOFTWARE
To change the advanced settings using the SMARTSET software:
1. Remove the memory card from the camera.
2. Insert the memory card into a computer.
3. Open the "SMARTSET.EXE" application located on the memory card.
4. Disable the "I.T.T. technology" to change the camera settings.
5. Change the desired settings using the different tabs selection.
6. Press "Save" to save the changes.
7. When completed, the "Configuration saved" message appears.
8. Press "OK".
9. Then press "Exit".
10. Make sure that the "settings.bin" folder was created and saved on the
memory card before removing it from the computer.
11. Insert the memory card into the camera.
12. Turn on the camera. The message "SETTINGS UPDATED" will appear to
indicate that the camera has recorded the new settings.
When using a new memory card, insert it into the camera and turn
it on for the SMARTSET software copy to the SD/SDHC card. The
SMARTSET software is always automatically copied from the camera to
the memory card.
4
6 9
5