Snakebyte Xbox 360 Media Remote Control Manual - Manual (Page 2)

Disposable Battery Safety
Improper use of batteries may result in battery fluid leakage, overheating, or explosion. Released battery
fluid is corrosive and may be toxic. It can cause skin and eye burns, and is harmful if swallowed. To
reduce the risk of injury:
• Keep batteries out of reach of children.
• Do not heat, open, puncture, mutilate, or dispose of batteries in fire.
• Do not mix new and old batteries or batteries of different types (for example, carbon-zinc and alkaline
batteries).
• Remove batteries if they are worn out or before storing for an extended period of time.
• If a battery leaks, remove all batteries, taking care to keep the leaked fluid from touching your skin or
clothes. If fluid from the battery comes into contact with skin or clothes, flush skin with water
immediately. Before inserting new batteries, thoroughly clean the battery compartment with a damp
paper towel, or follow the battery manufacturer’s recommendations for cleanup.
• Dispose of batteries in accordance with local and national disposal regulations, including those
governing the recovery and recycling of waste electrical and electronic equipment (WEEE).
SET UP YOUR XBOX 360™ MEDIA REMOTE CONTROL
Insert Batteries
1. Lift up the battery cover.
2. Insert two new AAA batteries as shown in the battery compartment.
3. Press down the battery cover.
Set up the Universal Remote for Your TV
The Media Remote Control has 23 keys (See illustration 1) those can work not only on Xbox 360™ but
can learn from other IR remote also. To set up the universal keys, you only need to do a few simple steps.
1. Press the TV key to change the mode for working on your TV.
2. Press the Set key until the green LED at the left top of the Media Remote Control completely lit up.
3. Press one of the universal keys on the remote, the green LED will start flashing slowly.
4. Point your TV remote towards the Universal Remote (Make sure the IR LED on the two remotes are at
the same level and within 3 cm, see illustration 2.) and press the key. When the green LED quickly
flashes twice and then turns off, the key is successfully set up the same function of the key on your TV
remote. If not, repeat the steps 2 to 4.
5. Repeat steps 2 to 4 to set the other universal keys.
After all the universal keys are successfully set up, the remote stays at the mode for working on your TV.
You can control your TV now or press the TV key to change the mode for working on your Xbox 360™
game console.
You can set up any key of an IR remote to the universal keys on the remote.
Notes:
1. The universal keys can only learn the keys of an IR remote.
2. The universal keys can only memorize the function the last time learnt.
3. When you use the Media Remote Control first time, the universal keys have no function in the TV
mode.
4. You need to set up each of the keys by doing the above 4 steps.