SATEC PM130 PLUS Quick Start - Manual (Page 3)

PM130 PLUS QuickStart www.satec-global.com
OPERATION
The PM130 PLUS is operated using the front panel which consists of a 3-line 7-segment
display, up to 33 LEDs (depending on model) and six keys as shown below:
There are two display modes: readings and menus.
Readings Mode
There are four groups of readings: Common measurement, Min/Max, Harmonics and Energy.
Use MAX/MIN or H
I I I I I I or ENERGY to switch between groups,  or  to scroll within the
group, or simultaneous  and  to go to the first screen of the current display group.
Menu Mode
Press SELECT to enter menu mode (blinking line indicates the selection). SELECT to change the
selection, ENTER to drill down or ESC to go up. In editing mode use  or  to change the
value (a number or submenu), ENTER to accept it, or ESC to cancel.
The following chart shows the structure of the menus:
  Phase rotation  Real Time Clock  Reset min/max, demands, etc.
  Voltage angles  Basic configuration  Same as OPS (Options) menu
  Current angles .COM2 setup 
  Relay status (*D) .COM2 setup (*E/G/R/P) 
 . DI status (*D)  Relay Output (*D)
  Counter value in 0.1 hours  Analog Output (*A)
 . Alarm setpoint  Network configuration (*E)
   Diagnostics  Setpoints
 . Serial number   Display
  Firmware version   Options
  GPRS status (*G)
NOTE: Option availability depends on installed add-in module:
*D – Digital I/O; *A – Analog Output; *E – Ethernet; *G – GPRS; *R – RS232/422/485; *P – Profibus.
Diagnostic LED. Off = OK
Load bar graph
(full load according to CT
or in Display Setup)
Displayed
parameters
Calibration LED
(1 pulse/Wh or Varh)
Measurement scale Communication indication
Main Display
Energy button & indication
(E/EH models) / Enter
Min/Max/Max Demand
button & indication
Harmonics button & indication
(EH model) / Escape
Select
Scroll up / down
 (Status)
Status Indications
 (Options)
Read-only
display of the configuration
screens
 (Change) Configuration