S&S Cycle Air Cleaner Covers - Manual (Page 4)

4
9- Install the Muscle cover over the pin studs followed by a flat washer, a spring washer, a flat washer and the lynch pin. Picture 8 illustrates the
Muscle cover assembled on the motorcycle.
10- Picture 9 illustrates a diagram of the Muscle cover and parts assembly.
Installing the S&S® Muscle Air Cleaner Cover for Stock CV Carburetors, Stock Delphi EFI and Stock Throttle by Wire Throttle bodies
using the S&S Stealth Air Cleaner Kit
1- Remove the air cleaner assembly from the motorcycle you are working on.
2- Locate the gasket that has the lanyards attached. Picture 10 illustrates the lanyard gasket.
3- Slide the lanyard gasket over the screws as illustrated in Picture 11.
4- Pass the breather bolts through the backplate mounting holes using the same number of rubber coated washers that were used prior to
disassembly.
5- Apply a drop of 243 blue Loctite® to the threads of each screw and breather bolt. Picture 12 illustrates all five fasteners that require 243 blue
Loctite.
6- Fit the backplate to the carburetor or throttle body and the cylinder heads. Start the threads of all the screws and tighten evenly until the
backplate is snug.
7- Now that the backplate is positioned, finish torque the ¼" X 20 fasteners to 72 in.-lbs. as illustrated in Picture 13.
Picture 9
Lynch Pin
Flat
Washer
Spring Washer Cover
Filter
Backplate
Picture 8
Picture 10 Picture 11
Picture 12
Apply 243 Loctite®
Picture 13