S&S Cycle Single Bore Induction Systems - Manual (Page 4)

4
5- For 2001-'05, slide the MAP sensor in place, being sure not to pinch the orange rubber seal—some clean engine oil may make this easier. For
1995-'01, refer to the module instructions to determine whether to install the MAP sensor or a plug. If the plug is used, apply some clean oil to the
O-rings. Install them on the plugs and then install the plug. Install the cable guide and verify it is aligned with the throttle cable actuator. Once
alignment is satisfactory, apply Loctite® 222 to the 10-24 x 1/4” screws and tighten to 18-22 in-lbs.
4- Install the new O-ring into the throttle body. A light film of clean engine oil can be used to help hold the O-ring in place. Align the manifold to
the throttle body, use purple 222 Loctite® on the 10-24 x 1” socket-head assembly screws (with flat washers) and tighten them to 35-40 in-lbs.
Replace this O-ring if the manifold and throttle body are taken apart after being used.
6- Using the new S&S supplied gasket, slide the Intake Air Temperature (IAT) sensor in place. Use Loctite 222 on the T10 Torx button head
M3 x .5 x 10mm screws and tighten to 6-8 in-lbs.
Picture 4
Picture 5
Picture 6
Picture 5a