S&S Cycle Intake Kit, PN106-5012 For 2008 – Up Polaris Ranger RZR and RZRs - Manual (Page 2)

2
TOOL REqUIREMENTS:
T-27 Torx® drive socket
•
5/16” Flat blade screwdriver
•
#3 Phillips screwdriver
•
#2 Phillips screwdriver RZRs models
•
1/2” Socket wrench
•
1/2” Combination wrenches
•
3/8” Combination wrench
•
Pliers
•
Saber saw with fine tooth scroll blade
•
Masking tape
•
Silicone sealer
•
Scissors
•
Thread sealer
•
Tape measure
•
Pencil
•
The safety of vehicle occupants is dependent on proper installation of this product. If you are not certain of your capabilities or do not
•
have the correct tools for this installation, please consult a dealer to have it done. Improper installation of this product could result in
injury or death to the rider.
Be sure to disconnnect the battery of your vehicle before starting on this procedure. Accidential starting of the vehicle could cause
•
injury to you or others around you during the installation.
BED REMOVAL: RZR AND RZRS
1- Remove seats from vehicle.
2- Remove rear main service panel (behind seats).
3- Disconnect the negative battery cable.
4- Disconnect the tail light wire. This is located right above the stock air box cover. See Picture 1.
5- Standard RZR models. With multi function pliers supplied in your RZR tool kit remove 6 plastic push rivets. See Picture 2.
On RZRs models remove rear roll cage section by removing the eight bolts (1/2” hex and ¼” hex key) that attach cage section. Next remove fender
flares from bed by removing ten Torx® drive screws (A), two Phillips head screws (B) and six plastic push rivets (C). See Picture 3.
WARNING
Picture 1
Picture 2 Picture 3
A
A
A
B
A
C
C