S&S Cycle Billet Generator Style Electronic Timer for S&S Super Stock Ignition - Manual (Page 6)

9- Install wire clip on center case bolt and torque to 8 ft-lbs as shown in Picture 13. Route the wires along the back side of the
pushrods, through the clip (Picture 14) and then along the frame. Be sure they do not contact any hot or moving parts.
10- Mount the VOES switch as close to the carburetor as possible using the included bracket. Note: There is no polarity
on the VOES so either wire can be used for ground or signal.
11- Connect the VOES hose from the switch to the nipple in the manifold. Trim the hose to be as short as possible
without stretching or kinking it.
NOTE: The Super Stock ® ignition is a single-fire design requiring a single fire coil with a minimum of 3.0 ohms resistance. Dual-plug
engines will require two coils or a four-tower coil.
6
Picture 13 Picture 14
Picture 15