S&S Cycle Billet Generator Style Electronic Timer for S&S Super Stock Ignition - Manual (Page 4)

3- Make sure the O-ring is in place on the driveshaft (Picture 4) and then install it with the index mark at approximately 3 o’clock
(using the threaded hole as 6 o’clock)—it will rotate approximately 60-degrees to the 1 o’clock position since the gear is a helical
design as shown in Picture 5.
4- Install the retaining bracket making sure not to rotate the driveshaft away from the 1 o’clock position. Align the cutout on the
mounting plate with the
1 ⁄
4
” 12-point screw and hand tighten, using a drop of threadlock.
5- The screw holes on the cup are indexed with the mounting plate—it can only mount in one position. Install screws hand tight
using threadlock. Once the cup is secure, rotate it until the dot aligns with the timing mark on the drive shaft. You can now tighten
the retaining bracket screw 65-70 in-lbs and torque screws in cup 15-20 in-lbs.
Picture 4 Picture 5
Picture 6 Picture 7
Picture 8 Picture 9
4
6 o’clock