S&S Cycle Billet Generator Style Electronic Timer for S&S Super Stock Ignition - Manual (Page 2)

Disconnect the battery of your motorcycle before attempting this installation.
Electrical connections are required to complete this installation. If you are unsure of your abilities to make these connections
safely, please take your motorcycle to a qualified shop for the installation.
This ignition system requires the use of VOES switch. If the VOES is inadvertently grounded, it will create an excess advance
situation which could damage the engine in your motorcycle.
INSTALLATION
IMPORTANT NOTES:
● If your ignition was installed at the factory in a complete engine assembly, do not adjust the module. Breaking the tamper resistant
seal will void your warranty.
● Factory installed Super Stock ® ignitions have a break-in rev limit feature. It will gradually raise the rev-limit over the first 24 hours
of running time from 4300 RPM to the maximum of 6300 RPM. Avoid dangerous situations that could require full power
maneuvers during this initial break-in period.
● The Super Stock ignition module comes pre-programmed from S&S ® for a specific engine size and style. You cannot modify the
ignition timing curve.
● This timer comes installed with a reverse rotation driven gear. Make certain you have a reverse turn drive gear installed.
● If your ignition was installed at S&S in a complete engine assembly, you should start at step 9.
2
Complete Installation Kit
DANGER
WARNING
DANGER