RKI Instruments GX-2009 Manual - Manual (Page 53)

GX-2009 Operator’s Manual User Setup Mode • 48
2. Press and hold the AIR button, then press and hold the POWER MODE
button. You will hear a beep after one second. Continue to hold both the
AIR and the POWER MODE button.
3. After three seconds you will hear a second beep. Release both buttons
when you hear the second beep.
4. If the PASSWORD menu item is set to on, the following screen will
appear with the first digit flashing prompting you to enter the password.
• Use the AIR button to scroll through the numbers 0-9 until you arrive
at the desired value, then press and release the POWER MODE
button to accept the value.
• Repeat the above procedure for each digit.
• When you have set and accepted the last digit of the password, the
first menu item in User Setup Mode will appear, the DATE Screen.
• If you entered the incorrect password, an error screen will
appear.You must use the POWER MODE button to turn the unit off
and try again if you wish to enter User Setup Mode or turn on the
unit and proceed to Measuring Mode.
5. If the PASSWORD menu item is set to oFF, the first menu item in User
Setup Mode displays, the DATE Screen.
6. Use the AIR button to move forward through User Setup Mode. When
you get to the last menu item, the START menu item, continuing will
take you to the beginning of the menu.
7. When you arrive at the item you wish to enter, press and release the
POWER MODE button to enter that item.
8. When you need to adjust the numerical value of a parameter, increase it
or decrease it, use the AIR button to change the value. When adjusting
a numerical parameter value, it is possible to reverse the direction of
0 0 0 0
PASSWORD
DATE
DATE