Retsch PM 400 - Manual (Page 24)

08.02.2012 Retsch GmbH
24
Doc. Nr. GB 98.535.9999
Speed 30 to 400 rpm
The PM400 is started with the preselected milling time and the preselected speed. Reversal of the
direction of rotation with pause time is not switched on.
Interval
00:00:01 to 99:59:59
Hours:Minutes:Seconds
The interval time can be set here, depending on the
milling time. If interval is not set then reversal of
direction of rotation cannot be set.
Reversal of direction
of rotation
YES
NO
The PM400 is started with the preselected milling time, speed and reversal of direction of rotation. The
machine rotates in one direction with the set interval time, comes to a stop and starts immediately after
standstill in the other direction without a pause time.
Pause time
00:00:01 to 99:59:59
Hours:Minutes:Seconds
The pause time can be set here between the intervals from
00:00:01 to 99:59:59 Hours:Minutes:Seconds.
If no interval is set then a pause time cannot be set.
The PM400 is started with the preselected milling time, speed, reversal of direction of rotation and
the set pause time. The machine rotates with the set interval time in one direction, comes to a stop
and after standstill the previously set pause time is displayed in the interval and counted down to
00:00:00. After the pause time has elapsed the machine starts in the other direction.
Programme mode
Take over parameters
Here all the previously set parameters, such as milling
time, speed, interval and pause can be stored in a store.
Set the required parameter.
Change to „Programme mode“ in the menu, press the setting knob and confirm „Take over
parameters” again. The menu shows „Milling programme“ and on the right the storage
location number.
Turn the setting knob to the right until you have found a milling programme with empty
storage locations or one which you wish to overwrite.
By pressing the setting knob you can reserve the selected storage location.
You can now choose between “Store parameter ?” or “Cancel”.
You will then be returned again into the “Programme mode” level.
Programme mode
Change programme
Here all previously stored parameters, such as milling time,
speed, interval and pause can be changed.
It is also possible to enter new parameters.
Select „Programme mode“, „Change programme“ and confirm with the setting knob. The
display shows the milling programme with storage location number again.
To select the „Milling programme“ to be changed press the setting knob;only the storage
location numbers are inverse; the milling programme is changed by turning the setting
knob.
Confirm the milling programme to be changed by pressing; you can now change the
parameters.
After this you can „Store (the changed) Parameters” or “Cancel”
You will then be returned again to the “Programme mode” level.
Programme mode
Delete programme Here all the previously stored parameters can be deleted.
Select „Programme mode“, press the setting knob and confirm „Delete programme” again.
Select the milling programme to be deleted by turning the setting knob and confirm by