Retsch PM 400 - Manual (Page 23)

08.02.2012 Retsch GmbH
23
Doc. Nr. GB 98.535.9999
E
By turning and pressing the setting knob E all menu points can be selected and
parameters set.
Turning 1
By turning, the various menu points can be selected. Selected menu points are
displayed inversely.
Turning 2
Setting of parameters in the opened menu points (see Pressing 1).
Pressing 1
Selected menu points are opened.
Pressing 2
Short pressing confirms setting of parameters.
Pressing 3
Continuous pressing: jump back to the 1st menu level.
Setting possibilities via the display menu
For the setting possibilities on the display described below please observe the menu structure on this page. The
selection bar in the display should be operated as follows:
Vertical manoeuvering through the structure by turning the setting knob
Horizontal manoeuvering through the menu structure by pressing the setting knob
Setting of numerical values or decisions by turning the setting knob
Confirmation of settings by pressing the setting knob
With “RETURN” you go to the previous menu structure level
By continuous pressing the setting knob you return to the basic screen
Languages
Menu Display Languages
You can select the language here. After selection and pressing the setting knob the complete menu structure is
shown in this language.
False language selection
If the wrong language is accidentally selected switch off the unit at the main switch.
Keep the buttons pressed simultaneously and switch on the unit again.
After selecting the correct language switch off the equipment and immediately on again.
Confirm your selection by pressing the setting knob.
The unit is now set permanently in your language and you are in the main menu.
Manual operation
If this function is set you can call and change all parameters and functions at any time.
This is also possible during milling.
Milling programme
To get to the „milling programme“ function press the setting knob with “manual
operation” set. Milling programme 1 appears, flashing, in the display. Furthermore
data which may already have been stored in milling programme 1 are also
displayed.
By turning the setting knob to the right you can select other milling programmes 2-
10. Any parameters which may have been stored are displayed each time.
You can start the machine directly with the selected milling programme.
To return to „manual operation“ turn the setting knob completely to the left and
confirm with the setting knob.
Milling time
00:00:01 up to 99:59:59
Hours:Minutes:Seconds
The PM400 is started with the preselected milling time and the speed last used. Reversal of
direction of rotation with pause time is not switched on.