Retsch MM 200 - Manual (Page 20)

5/21/2012 20 Retsch GmbH
value.
Storing the milling parameters
Storing or calling the preselected milling parameters can be
carried out only in the on mode. You can change the
programme positions P1 to P9 at any time and overwrite
these.
After switching on the MM 200 „on“ appears in the display L.
By pressing the button PROG the next programme position P1
to P9 can be obtained. After programme position P9 “on”
reappears in the display. In the PROG mode all buttons, apart
from PROG, START and STOP are blocked.
When the display shows on
the frequency M and time N are freely adjustable.
When the display shows P1 to P9
milling parameters can be stored and called.
Start = the milling process is started with the selected
programme or the parameters freely selected under
“on”.
Allocating the storage location
Press button PROG once or several times until the
required storage location P1-P9 has been reached.
Press SET button – all display flash.
Set frequency M and time N.
The programming mode can be discontinued by pressing the
button PROG – the values are not stored.
Press SET button – the values are stored.
Flashing of the display stops, the adjustment interlock is
activated and the milling parameters are stored.
Operating hours display
If the buttons described below are pressed in the stand-by mode
the complete running time of the machine is shown in hours and
minutes.
Display operating hours :
Press buttons M+ and SET simultaneously and keep pressed.
„bS“ appears in the display “memory”.
hhh hhh
Leave operating hours:
Press STOP button.
PROG SET
L
M+ SET