Retsch MM 200 - Manual (Page 14)

5/21/2012 14 Retsch GmbH
Electrical connection
The voltage and frequency for the MM 200 are
given on the type plate.
Ensure that these values correspond to the
available power supply system.
Connect the MM 200 to the power supply system
using the supplied connection cable.
Protection by external fusing is to be used when
connecting the mains cable to the power supply,
according to the regulations at the place of
installation.
The voltage supply of the MM 200 must be fitted
with a fault-current circuit breaker (FI switch).
If the values on the type plate are not observed this can
result in damage to the electrical and mechanical
components.