Retsch BB 100 - Manual (Page 19)

2/7/2012 Retsch GmbH
19
Safety instructions (table) for the BB 100 taken from the chapters
Procedure Action Dangers
Safety Not paying attention to the safety instructions
can lead to damage to people and property. Claims for damage are excluded in whatever form.
Packaging Please retain the packaging for the duration of
the guarantee period. In the case of complaint your warrantee rights can
be endangered if the item is returned insufficiently
packaged
Transport During transportation the BB 100 should not be
knocked, shaken or thrown. Electronic and mechanical components can
become damaged.
Temperature variations With severe variations in temperature, the BB
100 must be protected from condensation. Electronic components can become damaged.
Scope of delivery In the case of the delivery being incomplete
and/or transport damage, you must inform the
carrier and Retsch GmbH immediately (within
24 h). Later complaints can under certain circumstances
no longer be considered.
Environmental temperature Drops below 5°C
Rises above 40°C Electronic and mechanical components can
become damaged. Performance data change by an
unknown extent.
Air humidity Rises above 80%
at temperatures up to 31% Electronic and mechanical components can
become damaged. Performance data change by an
unknown extent.
Setting-up Set the BB 100 up only on a level, secure
surface. Anchoring should, in order to
satisfactorily guarantee that the jaw crusher
cannot overturn, be carried out making use of
the holes in the feet of the BB 100. Without being secured to the floor, the BB 100
cannot achieve the level of security against
overturning required by EN 61010. Components
can become damaged. Danger of crushing for
arms and feet.
Electrical connection Mains supply does not match the values given
on the type plate. Electronic components can become damaged.
Operation During starting, stopping and disconnection,
there must be no material for grinding in the
crushing chamber or in the feed hopper. Mechanical components can possibly become
damaged via a blockage.
The crushing chamber is not be filled by more
than 2/3. Otherwise the guide plates of the feed hopper can
becoming damaged and the material for grinding
will be delivered by the breaking arm into the
crusher housing behind the arm.
Cleaning Each time before cleaning, pull out the mains
plug. Danger of death by electrocution.
Do not clean with running water. Danger of death by electrocution.
Solvents are not permitted. Since they would damage the felt seals on the sides
of the breaking arms or wash out the grease filling.
The filling hopper may be swung back for
cleaning, by unscrewing the two socket screws,
only by assigned, trained personnel. Operation
of the BB 100 without screwed-in socket screws
and without the filling hopper is not permitted. Danger of crushing for fingers and hands.