Purus Living 800 - Drop/Twist Grate - Manual (Page 8)

8
PURUSLINE LIVING WETROOM SOLUTION Wooden floor
02831
Flexible grout
Tiles
Tile adhesive
After the tiles are installed, joint the tile
frame with flexible grout.
Stage 9
For tiles of height between 10-26mm the
six or eight adjustment screws are available
in two separate lengths in order to manage
tiles between 10-26mm.
Adjust the height of the adjustment screws
to the height of the tile including the
thickness of the bed of tile adhesive you are
going to use, so it is flush with the top of the
tiles.
Never use power tools to screw in the
screws.
NOTE: Rebate: The tiles should be butted up
to the rebate (see diagram), but never cover
the rebate or the grate itself.
Stage 10
After adjusting the height, turn the frame
upside-down and fill the frame-edge fully
with tile adhesive to fix the grate into
position.
Then turn the frame back over and install it
while the adhesive is still wet.
NOTE: When installing, the whole area
around the frame should be filled with
adhesive.
The grate when installed must be horizontal
and flat. It also must be level with the ceramic
tile surface and not at an angle or on a slope.
Tile the tray to the desired pattern, using
flexible EN12004 C2 classified tile adhesive
applied using a notched trowel in accordance
with the code of practice BS5385:2009.
Finally grout the gaps with flexible, water
proof, anti-mould grout, ensuring that no
grout falls into the gully body. Allow to dry
and settle for 48 hours.
If tile adhesive or grout falls into the gully
immediately clean it up.
Remove grate supports from underneath
the grate.
NOTE: Once installed and the grout is fully
dry, check for leaks before using.
Fix Tiles to BS5385 Standard.
15
Tile
adhesive
Frame edge
Rebate
Height adjustment
screws