Purus Living 800 - Drop/Twist Grate - Manual (Page 6)

6
PURUSLINE LIVING WETROOM SOLUTION Wooden floor
02831
Stage 4
Place the gully and joist installation rails
in position and check it is level and 10mm
above the floor.
Once level, screw and fix into the joists using
the screws supplied. If you have 22mm
floorboards you will need the packers for
22mm floorboards. Place these on the joists
before screwing and fixing the gully and rails
into the joists.
Do not use power tools.
Waste pipes
If your waste pipe is an ABS plastic 1½
inch or 42.9mm pipe then you can use
the supplied 42.9mm (1½ inch) ABS pipe
adapter provided for solvent welding and
connecting to the 42.9mm (1½ inch) waste
pipe.
The push fit end must be fully inserted
into the gully prior to connecting to the
waste pipe. The gully and adapter can then
be solvent welded to the waste pipe by a
fully qualified professional plumber. If the
waste pipe is not an ABS plastic 1½ inch
or 42.9mm pipe then a mechanical fixing
connector must be used to connect the
gully outlet to the waste pipe by a fully
qualified professional plumber. Once the
gully has been connected to the waste pipe
and tested for leaks by your fully qualified
plumber, the hole cut for connecting the
pipe should be made good.
If you have existing walls covered with
plaster or plasterboard use Puragum Primer
to seal the walls. If the walls are not covered,
then clad walls with panels or plaster board
(not supplied) and coat with Puragum
Primer (follow the instructions provided in
the tanking kit).
IMPORTANT: Always ensure you do not apply
Puragum Primer to the tray.
10 mm
10 mm
Stage 5
Apply either the compound adhesive 3712
in 50mm lines as a 3-5mm bead onto the
floorboards, or a 3mm bed of tile adhesive
to cover the area of the tray. If using the
compound adhesive you will need two
tubes.
Lay the tray into position. Countersink and
screw the tray down to the floorboards at
150mm (6inch) centres.
IMPORTANT:
Ensure you avoid screwing through any
pipework, cables or services etc.
Follow this step until you have fitted the
whole tray.
Use dry wall
screws
(not supplied).