beautypg.com

Zipper foot, Basic sewing (3) – Brother PQ-1500 User Manual

Page 19

background image

CONTENTS

Accessories

Names of

Parts

Before You

Begin

Changing

Needles and

Light Bulb

Threading

Stitch

Samples and

Needle Chart

Changing

Presser Feet

Basic

Sewing

Caring for

Your

Machine

Trouble

Shooting

15

Basic Sewing (3)

Note

• Make sure power is off before changing feet.
• When attaching zippers to stretch fabrics, use the pin feed method

and adjust foot pressure accordingly.

Zipper Foot

1

Attach zipper foot.

2

Turn hand wheel to lower needle
and adjust position of foot to
needle.

5

Sew zipper onto fabric along
mark.

Make sure the needle does
not strike the metal part of the
zipper when sewing. The
needle may break and cause
injury.

3

Line up zipper to the section of
fabric it will be attached to, and
mark the base of the opening on
the fabric. It should be set ap-
proximately 0.5 cm below zip
stop.

4

Fold hem about 0.2 cm from
mark, and make a mark along the
edge. Separate the seam allow-
ance.

A

0.5 cm

Stop

Slide

Base of
Opening

0.2 cm

6

Line up folded seam to stitches.

7

Change position of zipper foot.

8

Turn hand wheel to lower needle
and make sure the needle and
position of the foot are lined up
properly.

9

Baste zipper onto fabric and sew
along edge with fabric right side up.

Reinforce base of opening by
sewing over it twice.

If the zipper slide gets in the way,
lower the needle all the way
through the fabric, lift the foot, and
move the slider out of the way.

B

This manual is related to the following products: