Powertrax 4110 - Manual (Page 15)

15
3. Place one end of a spring assembly into the win-
dow hole, behind the pin (Figure 10). Compress it with a small
screwdriver and pop the bottom into the window hold (Figure
11). Push on the bottom coils to be sure that the spring snaps in
and is seated all the way (Figure 12). Rotate the drivers and do
the same procedure for each of the other three pins and springs.
4. Reach in through the recesses with your fingers and
be sure that the spacers are pushed outward, onto the couplers.
5. Rotate the drivers so that the large recesses line up
with the pinion shaft holes in the differential case.
6. If an axle shaft thrust block is being used, push it
into the center of the assembly through one of the couplers and
line up the large hole with the pinion shaft holes.
7. Carefully insert the pinion shaft into the hole and
guide it through the drivers, past the spacers (and through the
thrust block if used). It should insert easily by hand. If not, tap
it in, being very careful not to get the inner end caught on some-
thing!
Figure 12
Seat end of spring assembly in hole bottom