Powertrax 4110 - Manual (Page 10)

10
Figure 5
Install pins in window holes
LOCK-RIGHT Installation
Preparing the Parts for Assembly
1. Coat the teeth of the couplers and drivers, the large
center holes of the drivers (Figure 4), and both sides of the thrust
waashers with medium grease. Also place a little grease in each
of the two window holes in each driver. The grease will help hold
things in place and assist with functioning until the gear oil circu-
lates.
2. Place a shear pin into each window hole. It should
be about flush (Figure 5).
3. Place a spacer into the center of each driver as seen
in Figure 5, (wide end toward the teeth if the spacer is not sym-
metrical).
4. Press a thrust washer (with grease added) onto the
back of each coupler (Figure 6).
5. Insert a small spring into each of the large springs
and add a little grease to the coils to hold them together. Set
them aside.