Vehicle speed, Throttle position, Coolant temperature – PLX Devices Kiwi MPG User Manual

Page 5: Engine check, Read code, Reset code, Setup mode, Set dollars/gallon, 5 engine check, 6 setup mode

www.plxkiwi.com

(408)745-7591

4.5 RPM

This mode shows your engine’s speed or (tachometer

revolutions/minute).

4.6 Vehicle Speed

This mode shows your vehicles’ speed. (Supported Units: MPH,

kmh)

4.7 Throttle Position

This mode shows your throttle position or position of your gas
pedal. This is great for determining how much “load” is exerted

on your engine.

4.8 Coolant Temperature

This mode shows your engine’s coolant temperature.

(Supported Units: Fahrenheit, Celsius)

5 Engine Check

5.1 Read Code

Press the ‘Set’ button in this mode will read off your error
codes in a procession. The number of error codes detected will
display first followed by a list of the error codes one at a time.

5.2 Reset Code

Press the ‘Set’ button in this mode to clear your engine check
light.

6 Setup Mode

6.1 Set Dollars/Gallon

This mode allows you to change the price of fuel. Press the set
button to enter you into the set mode. When you’re in this

mode, press the mode button to change the digit position.
Press the set button to increment the number. To exit, press
the mode button until none of the digits are blinking. If your
units (see section 6.4) is set to 0, the price reflects dollars per
gallon. If your units (see section 6.4) is set to 1 or 2, the price

reflects dollars per liter.