PLX Devices Kiwi 2 Wi-Fi User Manual
Setting up the kiwi 2 wifi, Step one, Step two
Version 1.0
Step One
Plug Kiwi® 2 Wifi into OBD II port
The OBD II port is typically located under the steering column and should not require any tools to access.
Step Two
On Apple iOS device, open Settings -> Wi-Fi
Step Three
Turn Wi-Fi ON (if OFF), tap “PLXKiwi2”
Step Four
Tap blue icon to the right of “PLXKiwi2”
Step Five
Select “Static” at the top and enter the following
a.
IP: 192.168.0.11
b.
Subnet: 255.255.255.0
For iPhone 4 and newer. Note: This setting will temporarily disable 3G/4G data while connected to
the Kiwi® 2 Wifi
c.
Set router: 192.168.0.10
Step Six
Confirm Wi-Fi selection and signal bars in status bar
Step Seven
Open the app of choice!
Before launching your app, ensure that your vehicle is started (either accessory mode or idling).
Setting up the Kiwi 2 Wifi
Standby function
The Kiwi® 2 Wifi has a
when not in use. It will go into
its the iOS app on their mobile device or a period of no data transmission.
The Kiwi® 2 Wifi can be awakened by a single press of the side button.