Pavement Ends 41522 Sun Cap - Manual (Page 2)

41522 pg 2 1110 Rev. A
Parts List
Step One
S NAP S UN C AP TO H EADER
Slide the pocket sewn along the front of the
SunCap over the edge of the header and
snap it to the snaps.
Step Two
S ECURE H EADER TO W INDSHIELD
Center the SunCap on the vehicle. Place the tabs on
the Header Knob Bases above the footman loops in the
windshield frame. Place a Header Knob Plate under a
footman loop. Install a Header Knob through the plate
and footman loop and thread it into the Header Knob
Base. Repeat this with both Header Knob Bases.
Step Three
I NSTALL S HORT T ENSION S TRAPS
Drape the SunCap over the speaker pod. Thread a
Short Tension Strap through the two buckles sewn to
the rear of the SunCap. Pull the straps under the pod
and hook each strap into the opening as shown. Pull
the end of each strap to tighten securely
Step Four
S ECURE F LAPS
Wrap the fl ap above the door opening around
the horizontal sport bar and fasten the hook
and loop. Repeat on both sides.
SunCap Qty - 1
Long Tension Strap, Part Number 424.14 Qty - 2
Short Tension Strap, Part Number 460.37 Qty - 2
Snap Fabric
to Header
Footman
Loop
Header
Knob Plate
Header
Knob Base
Header
Header
Knob
View from Rear SunCap
SunCap
Hook Strap
into Hole
Pull End
of Strap
to Tighten
Thread Strap
through Buckle
Wrap Flaps around
bars and fasten
Hook and Loop