Brainboxes RS232 User Manual

Page 31

Manual for BL-521 5_3.doc

Page 31 of 41

9.1.2. Configuration by Menu

Select option 2 from the “Main Menu” menu to
display the Bluetooth settings menu shown below
left.

You should enter here the Bluetooth Address
(BD_ADDR) of the remote (server) device you wish
to pair (in our case this is 000A-4F-00082D)
followed by ENTER.

This should be in the same format as indicated on
the products label (NAP-UAP-LAP, for those of you
who know)

Press “Esc” to skip this section

Press C to select the client option. This setting is
stored immediately and is not discarded upon a
reboot. In fact it requires a re-boot in order to
activate it.

Press “Esc” to skip this option

Re-boot (power cycle) your converter. When the Client BL-521 is switched on, it will connect to the Server device
you have entered in the menu above, assuming of course that the server device is also powered up. Remember of
course that the factory shipped configuration of the converters is “server” so only 1 device needs any modification in
this respect