Orbit Baby G3 Stroller Base and Stroller Seat - Manual (Page 19)

Manual Text Booklet – Orbit Baby Stroller Seat and Stroller Base – ENGLISH – 11
⚠
WARNING
⚠
PINCH HAZARD:
◦
Keep hands and fingers, especially of children, clear of moving parts as you secure your
child in the stroller seat.
Securing your child
⃞ If your child weighs less than 15 lbs (7 kg), place the Orbit Baby Infant Insert Ⓛ in the stroller seat
before loading your child.
⃞ Open one side of the support bar Ⓓ by pushing on the oval button. Hook the buckle tongues of
the restraint harness Ⓞ in the upholstery flaps to keep them out of the way while loading the child.
⃞ Place your child in the stroller seat. Place the restraint harness around your child and insert the
buckle tongues into the crotch buckle Ⓟ. You should hear two CLICKS. Adjust the harness to
tightly fit around your child by pulling up and down on the webbing pull tab Ⓝ. To release the
buckle, press the red buttons while simultaneously squeezing the side tabs. See section for
adjusting the height of the shoulder straps.
⃞ Close the support bar. You should hear a CLICK. Adjust the footrest position to fit your child
by pulling on the footrest lever Ⓗ located underneath the footrest. When using seat with Helix
SmartHub Attachment, avoid injury to the child in rear seat from kicking or contact with
footrest on stroller seat; only use footrest adjustment position 1 when stroller seat is rear-facing
on the front SmartHub.
Adjusting the shoulder strap height
⃞ The height of shoulder straps can be adjusted based on the size of your child. They should be
positioned in the slot at or slightly above your child's shoulder.
⃞ If the straps need adjustment, remove your child from the seat and detach top portion of
upholstery.