Han- yellock – Northern Connectors Harting Han-Yellock Industrial Connectors User Manual

Page 4

Han-

Yellock

Han-Yellock

Inserting the module into the hoods/housing

• The Han-Yellock

module should only be in-

serted into the „A“ plug-in position in the metal

clamp.

① plug-in position „A“

• The illustration shows the orientation of the mo-

dule (see arrangement of contacts 1 ... 5).

① Carrier hood, mating side

② Carrier hood, connection side

③ Housing, bulkhead mounting, mating side

④ Housing, bulkhead mounting, connection side

• A distinct click can be heard when the module

snaps into position. It is then pushed along the

rail to its final position. The plug-in slots must

always be completely filled.

Disassembling the Han-Yellock

module

• The removal tool (part no.

quired to take out the module.

• The following illustration shows how to insert

the removal tool into the metal clamp. The tool

should then be pressed down until it reaches the

end stop.

• The tool is then pulled back and the module

comes out of the housing.

• The removal can be made from the connection

side as well as from the mating side.

① removal tool

② housing, bulkhead mounting

The process is identical for both housings, bulkhead

mounting, and carrier hoods.

The removal tool can be stored on the carrier hood:

① removal tool

② carrier hood