Northern Connectors Souriau UTL Series Push-Pull Connectors - Manual (Page 34)

34 © 2012 – SOURIAU
UTL Series
Technical information
• Strip external cable jacket
• Strip wires, crimp contacts
• Insert contacts into connector cavities (insert manually or use tool RTM2
0 5 crimp contacts)
• Do an overmolding on the wired set
UTL 6 assembly
• Slide nut on the cable
• Strip wires, crimp contacts
• Insert contacts into connector cavities (insert
manually or use tool RTM2
0 5 crimp contacts)
• Seat o-ring, place receptacle in the panel cut-out
(see dimension page 15)
• Tighten jam nut
• Jam nut torque: 2.5 Nm maxi, tool tightening: 7/8"
O-ring
O-ring Finally
Jam nut
Panel thickness:
3mm max
UTL 7 assembly (mounting suggestion)
Assembly instruction