Multiquip MP2090HP - Manual (Page 11)

MQ MP2 MASONRY SAW — OPERATION MANUAL — REV. #2 (3/12/13) — PAGE 11
Blade Safety
■ Use appropriate blades manufactured for use on masonry
saws.
■ Always inspect blades before each
use. The blade should exhibit no
cracks, dings, or flaws in the steel
centered core and/or rim. Center
(arbor) hole must be undamaged
and true.
■ Examine blade flanges for damage, excessive wear and
cleanliness before mounting blade. Blade should fit
snugly on the shaft and against the inside/outside blade
flanges.
■ Ensure the blade is marked with an operating speed
greater than the blade shaft speed of the saw.
■ Only cut the material that is specified by the blade. Read
the specifications of the blade to ensure the proper tool
has been matched to the material being cut.
■ Always keep blade guards in place.
Exposure of the blade must not
exceed 180 degrees.
■ NEVER touch or try to stop a
moving blade with your hands.
ALWAYS keep hands clear of the
blade.
ALWAYS check to make sure that the
operating area is clear before starting the
engine.
Safety - Electric Powered Models
■ ALWAYS connect the motor to a power source in
compliance with all local electrical codes. This must be
performed by a
licenced electrician.
■ ALWAYS use only outdoor approved GROUNDED
extension cords.
■ MAKE CERTAIN the power cord/extension cord is free
from damage and that the grounding circuit is operational.
■ MAKE CERTAIN the extension cord used is intended to
be used in the environment you will be using it in. If an
extension is used, NEVER submerge the connection in
water. To reduce the risk of electrical shock, always make
water-tight connections.
■ MAKE CERTAIN the "ON/OFF" switch is in the "OFF"
position before plugging in the power cord/extension cord
to avoid accidental starting.
■ ALWAYS stop the motor before servicing. MAKE
CERTAIN the motor is stopped and turned "OFF" at the
switch, and the power cord is disconnected from the
power source.
■ Use only the guage wire and length of cord recommended
for the motor size.
■ When cutting, ALWAYS be aware of the location of the
cord.
General Safety
■ ALWAYS read, understand, and follow procedures in
Operator's Manual before attempting to operate
equipment.
■ ALWAYS be sure the operator is familiar with proper
safety precautions and operating techniques before using
the saw.
■ NEVER leave the machine unattended while running.
■ Block the unit when leaving or when using on a slope.
■ ALWAYS check to make sure that the operating area is
clear before starting the engine.
■ Maintain this equipment in a safe operating condition at
all times.
■ AVOID wearing jewelry or loose fitting clothing that may
snag on the controls or moving parts, this can cause a
serious injury.
MP2 MASONRY SAW — RULES FOR SAFE OPERATION
WARNING - Clear Area Of Obstructions
■ ALWAYS keep clear of rotating or moving parts while
operating the saw.
■ ALWAYS store equipment properly when it is not being
used. Equipment should be stored in a clean, dry location
out of the reach of children.
■ NEVER use accessories or attachments which are not
recommended by the manufacturer for this equipment.
Damage to the equipment and/or injury to user may result.