MTS Landmark Tabletop - Manual (Page 67)

Handset Controls and Indicators
Description Control/Indicator Item
Displays previous or next text in the display. Page 1
Indicator. When lit, indicates the system is active (power applied). Active 2
Scrolls the highlighted selection down. Selection cycles to the top
when the bottom line is highlighted and the switch is pressed. Scroll Highlight 3
Makes fine actuator adjustment (towards display – up; away from
display – down). Only if Handset Enable is active. Thumb-Wheel 4
Pauses the test action. This must be pressed again for the test
to resume. Only if the application test software is active. Pause 5
Stops the test action. Only if the application test software is active. Stop 6
RJ-45, to Controller. Connector 7
Shuts down the HPU. Hydraulic Off 8
Starts the test action. Only if the application test software is active. Start 9
Resets active interlock(s) providing the cause for the interlock(s)
has been remedied. Interlock Reset 10
Press to enable the thumbwheel to position the actuator. Press
again to disable the thumbwheel. The indicator lights when the
thumbwheel is active. Thumbwheel Enable 11
Indicator. When lit, indicates an active fault or interlock. Fault 12
Used to enable/disable the handset. When the indicator is lit, the
handset is enabled for control of the actuator. Handset Enable 13
Selects the highlighted line in the display. Select (Enter) 14
Four lines, 20 characters per line.
Display
15
Standard Test Area Enclosure Operation
There are four operating modes for an MTS Landmark Test System:
• Hydraulic Power Off
• Specimen Installation and Setup
• Run Mode
• Service
MTS Landmark™ Tabletop Load Units Product Information 67
Operation