MK Diamond MK-101 Blade Alignment - Manual (Page 3)

MK-101 Type Blade Alignment Revision 12/00, Effective Date: December 04, 2000 Page-3
MK-101 TYPE BLADE ALIGNMENT PROCEDURE
90º Alignment Verification:
90º-alignment verification ensures the blade cuts tile straight up and down and not at an angle.
NOTES: If the blade is misaligned following 90º-alignment verification, return the saw to MK Diamond for repair.
The Diamond Blade must be removed and reinstalled when removing the Blade Guard.
(E)
Move Wheel Assembly
up or down to Square the
Movable Cutting Table
(B)
Position Square on Movable
Cutting Table against
the Diamond Blade
(A)
Remove Blade Guard
(C)
Verify the Diamond
Blade is Square to the
Movable Cutting Table
(F)
After Squaring, Tighten Movable
Cutting Table Wheel Assembly
Rotate Clockwise
to Tighten
Direction of
Movement
Wheel
Assembly
Wheel Assembly
Retaining Bolts
Rotate Counter-
clockwise to Loosen
1/2-inch
Wrench
Blade Guard Rotate Counter-
clockwise to Loosen
Diamond Blade Square No Gaps between
Blade and Square
1/2-inch
Wrench
(D)
If not Square, loosen Movable
Cutting Table Wheel Assembly
to adjust
(G)
Re-verify the Diamond Blade
is Square to the Movable
Cutting Table
No Gaps between
Blade and Square
Blade Guard
Retaining Nut
Wheel Assembly
Retaining Bolts
Movable Cutting Table